Dobrica Pavlinušić's random unstructured stuff
ESP8266: Revision 24



links

ESP-01 pinout

module_v2.png

  • all IO is 3.3V (3.6V max)
  • CH_PD i chip-enable and has to be connected to VCC (3.3V)
  • RST, GPIO0, GPIO2 should be pulled up to VCC for normal operation (GPIO0 at minumum!)
  • GPIO0 pull to ground for firmware update
  • make sure that 3.3V VCC power supply can support 300-400mA or there WILL be problems!

serial port

baud rate 115200

AT+GMR
00160901

OK

AT+RST

OK

 ets Jan  8 2013,rst cause:4, boot mode:(3,7)

wdt reset
load 0x40100000, len 24444, room 16 
tail 12
chksum 0xe0
ho 0 tail 12 room 4
load 0x3ffe8000, len 3168, room 12 
tail 4
chksum 0x93
load 0x3ffe8c60, len 4956, room 4 
tail 8
chksum 0xbd
csum 0xbd

ready


ESP-201

http://www.banggood.com/ESP8266-ESP-201-Remote-Serial-Port-WIFI-Transceiver-Wireless-Module-p-964288.html

ESP8266-ESP-201-pin-reference-v01.png

from http://smarpl.com/content/esp8266-esp-201-module-first-impressions

One quirk with the ESP-201 is that is IO15 has to be grounded for the device to function. To flash the device IO00 has to be grounded.

AT+RST

OK

 ets Jan  8 2013,rst cause:4, boot mode:(3,7)

wdt reset
load 0x40100000, len 212, room 16 
tail 4
chksum 0x5e
load 0x3ffe8000, len 788, room 4 
tail 0
chksum 0x1c
load 0x3ffe8314, len 72, room 8 
tail 0
chksum 0x55
csum 0x55
jump to user1


nodemcu

esptool.py

dpavlin@x200:/rest/cvs/esptool$ git remote -v
origin  https://github.com/themadinventor/esptool (fetch)
origin  https://github.com/themadinventor/esptool (push)

dpavlin@x200:/rest/cvs/esptool$ ./esptool.py --port /dev/ttyUSB2 read_mac
Connecting...
MAC: 18:fe:34:a0:38:72

flash firmware

dpavlin@blue:/opt/Espressif/esptool$ ./esptool.py read_mac
Connecting...
MAC: 18:fe:34:a0:38:72
dpavlin@blue:/opt/Espressif/esptool$ ./esptool.py --port /dev/ttyUSB0 write_flash 0x00000 ../nodemcu-firmware/pre_build/latest/nodemcu_latest.bin 
Connecting...
Erasing flash...
Writing at 0x00010800... (17 %) 


build from source

For latest features, you might want to rebuild software from github source

dpavlin@x200:/rest/cvs$ git clone https://github.com/pfalcon/esp-open-sdk.git



git clone https://github.com/nodemcu/nodemcu-firmware.git
cd nodemcu-firmware
make && make flash