Dobrica Pavlinušić's random unstructured stuff
ESP8266: Revision 13


links

pinout

module_v2.png

  • all IO is 3.3V (3.6V max)
  • CH_PD i chip-enable and has to be connected to VCC (3.3V)
  • RST, GPIO0, GPIO2 should be pulled up to VCC for normal operation (GPIO0 at minumum!)
  • GPIO0 pull to ground for firmware update
  • make sure that 3.3V VCC power supply can support 300-400mA or there WILL be problems!

serial port

baud rate 115200

AT+GMR
00160901

OK

AT+RST

OK

 ets Jan  8 2013,rst cause:4, boot mode:(3,7)

wdt reset
load 0x40100000, len 24444, room 16 
tail 12
chksum 0xe0
ho 0 tail 12 room 4
load 0x3ffe8000, len 3168, room 12 
tail 4
chksum 0x93
load 0x3ffe8c60, len 4956, room 4 
tail 8
chksum 0xbd
csum 0xbd

ready